Regulatory & Compliance
FCC regulatory notice
The following regulatory notices apply to the Conexio Stratus Pro Development Kit based on nRF9151, nRF9161, and nRF9160.
This kit has not been authorized under the rules of the FCC and is designed to allow:
• Product developers to evaluate electronic components, circuitry, or software associated with the kit to determine whether to incorporate such items in a finished product.
• Software developers to write software applications for use with the end product.
This kit is not a finished product and when assembled may not be resold or otherwise marketed unless all required FCC equipment authorizations are first obtained. Operation is subject to the condition that this product does not cause harmful interference to licensed radio stations and that this product accepts harmful interference. Unless the assembled kit is designed to operate under part 15, part 18, or part 95 of 47 CFR Chapter I - FCC, the operator of the kit must operate under the authority of an FCC license holder or must secure experimental authorization under part 5 of the latter chapter.
FCC Pre-certification and Markings
When designing or incorporating the Conexio Stratus into your projects, there are some marking requirements. The host device shall be properly labeled to identify the modules within the host device and you must have this written on your product somewhere:
Contains FCC ID: 2ANPO00NRF9160
Contains IC: 24529-NRF9160
FCC Supplier's Declaration of Conformity (SDoC)
This equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment.
The antenna should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
EU Declaration of Conformity (DoC)
UKCA Declaration of Conformity (DoC)
Last updated
Was this helpful?